James Mason

Setting out the desk…

The 3D desk needs JavaScript. Every project is listed below, and each has a page of its own.This browser draws 3D without graphics acceleration, so the desk would be slow. Every project is listed below.

Section 04 / 06

Automation & systems

The desk

Freelance · Mastersounds · 2025

Technics 1210 instructions

Isometric line drawing of the assembled Technics 1210 turntable on its feet, with platter and tonearm fitted.
The assembled 1210.Drawing: James Mason
Exploded isometric line drawing of a Technics 1210: platter and tonearm above the top plate, chassis and base below.
Instruction drawing for 1210 disassembly and reassembly, from a SharkCAD model, July 2025.Drawing: James Mason
Isometric line drawing of the 1210 top plate with the platter and tonearm in place.
Top plate, platter and tonearm.Drawing: James Mason
Line drawing of the turntable base separated into its ribbed lower casting and the plate above.
Step drawing from the same set: base and casting.Drawing: James Mason
Isometric line drawing of the 1210 base from below, with its four feet lifted away.
The base with its feet removed.Drawing: James Mason
Isometric line drawing of a shallow rectangular lid with a circular cut-out near one corner.
The lid, from the same set.Drawing: James Mason

Instruction drawings for customers taking a Technics 1210 apart, fitting a new Mastersounds tonearm and packing the turntable for transport to Mastersounds.

My role

I produced the isometric instruction and packaging drawings from a SharkCAD model.

  • Isometric instruction and packaging drawings from a SharkCAD model

The drawing set

  • The assembled turntable
  • The exploded stack: platter and tonearm, top plate, chassis and base
  • The top plate with platter and tonearm
  • The base and its casting
  • The base with its feet removed
  • The lid

Each drawing is an isometric view taken from one SharkCAD model.

Outcome

In use as customer instructions.

Next in Automation & systemsLive BOM system →